Cool Weapons

[footfootfoot]

Holy hot mess, Batman:

Airframe, canopy and landing gear[edit]
On most aircraft, use of titanium was limited by the costs involved; it was generally used only in components exposed to the highest temperatures, such as exhaust fairings and the leading edges of wings. On the SR-71, titanium was used for 85% of the structure, with much of the rest polymer composite materials.[24] To control costs, Lockheed used a more easily worked alloy of titanium which softened at a lower temperature.[N 3] The challenges posed led Lockheed to develop new fabrication methods, and have since been used in the manufacture of other aircraft. Welding titanium requires distilled water, as the chlorine present in tap water is corrosive; cadmium-plated tools could not be used as they also caused corrosion.[25] Metallurgical contamination was another problem; at one point 80% of the delivered titanium for manufacture was rejected on these grounds.[26][27]

The high temperatures generated inflight required special design and operating techniques. Major portions of the skin of the inboard wings were corrugated, not smooth. Aerodynamicists initially opposed the concept, disparagingly referring to the aircraft as a Mach 3 variant of the 1920s-era Ford Trimotor, known for its corrugated aluminum skin.[28] The heat would have caused a smooth skin to split or curl, whereas the corrugated skin could expand vertically and horizontally and increased longitudinal strength. Fuselage panels were manufactured to only loosely fit on the ground. Proper alignment was achieved as the airframe heated up and expanded several inches.[citation needed] Because of this, and the lack of a fuel sealing system that could handle the airframe's expansion at extreme temperatures, the aircraft leaked JP-7 fuel on the ground. After takeoff, the aircraft would perform a short sprint to warm up the airframe, then refuel before heading to its destination.[citation needed]

The outer windscreen of the cockpit was made of quartz and was fused ultrasonically to the titanium frame. The temperature of the exterior of the windscreen reached 600 degrees[clarification needed] during a mission.[29]

Cooling was carried out by cycling fuel behind the titanium surfaces in the chines. On landing, the canopy temperature was over 300 °C (572 °F).[28] The red stripes on some SR-71s were to prevent maintenance workers from damaging the skin. Near the center of the fuselage, the curved skin was thin and delicate, with no support from the structural ribs, which were spaced several feet apart.[30]

The Blackbird's tires, manufactured by B.F. Goodrich, contained aluminum and were filled with nitrogen. They cost $2,300 and did not last even 20 missions. The Blackbird landed at over 170 knots and deployed a drag parachute to stop; the chute also acted to reduce stress on the tires.[31]

[Lamplighter]

What could go wrong ???

[xoxoxoBruce]

Not much, they worked very well. Ridiculously expensive and inefficient, but looking at the operating parameters... Damn.

Back on earth...

[glatt]

When a Tommy gun and Gatling gun have a baby and feed it steroids.