It's dead Jim, PC help required, others may also opine.

[tw]

Originally Posted by Beest

I measured the voltages I did by pulling the plug and putting the probes in that end, I'll see if I can slip them down the side to get a reading while still plugged in.

Don't slip a probe. Saying again. Jam that probe inside the connector hole for each wire. Disconnect, disassemble, or remove nothing. Do not even move a connector. Jam that probe in with aggression. If the probe is bigger than the hole, then wrap a paper clip onto the probe and stick the paper clip end into the hole. But, if not clear before, absolutely do not move, partially move, disconnect, disassemble, or remove anything (but the already removed cover plate).