Learning how to build an electric guitar

glatt · 04-15-2019, 07:56 PM

Yeah. Absolutely.

The fret board is done by cnc. For the wires and little dots.

Working there would be decent as a summer job, but each task was too specialized to hold my interest for any real time. This one lady was sanding by hand the bracing that is attached to the face panel. There are a dozen or so surfaces to sand on each guitar, and she said she does about 150 guitars a day. That would get old after a month or so.

04-15-2019, 07:56 PM	#11
glatt ™ Join Date: Jul 2003 Location: Arlington, VA Posts: 27,717	Yeah. Absolutely. The fret board is done by cnc. For the wires and little dots. Working there would be decent as a summer job, but each task was too specialized to hold my interest for any real time. This one lady was sanding by hand the bracing that is attached to the face panel. There are a dozen or so surfaces to sand on each guitar, and she said she does about 150 guitars a day. That would get old after a month or so.

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)