|
There are a couple of ways I can imagine for that task. Toenail/brad the strips to each other like hardwood flooring. They'd stick to each other but pull out of the foam. But then you'd have a canoe interior full of brad points. Uncomfortable. Or... staples. That's what I used. A million staples. That's a million going in and a million to pull out. Or hotglue on the formside (pehaps covered in some mold release/plastic sheeting). The hotglue could easily be rubbed off the inside of the canoe once it was cooled and the form removed.
I just can't see forms three inches apart for the length of the boat. What a pain.
__________________
Be Just and Fear Not.
|