Let's see. Where are we? Last weekend was a 3 day weekend, and I got a few hours in.
I had been working on the table mount system. The block that supports it all needs to have bolt holes drilled into it to bolt it to the frame. Pretty straight forward stuff.
I mark the hole locations. I'm anal about this, but don't know why. It doesn't matter much exactly where the bolts go, and they will be out of sight.
First I use large forstner bit to make room for the bolt heads and washers.
Then I drill the center bolt holes in the little divot left in the center by the forstner bits.
It will look like this with bolts in place.